Project Call 4.0’s diverse scope of needs represents technology and capability gaps that have been determined by the community over a wide range of application areas – from digital health to commercial aviation to national security needs. These areas cover the spectrum from encapsulation technologies for wearables, high performance and high layer count FHE, to 3-dimensional electronic design software, solutions for challenges in e-textiles, biochemical monitoring platforms, and lightweight electronics for drones and UAVs.
“NextFlex’s Project Call process has proven to be extremely successful,” said Dr. Malcolm J. Thompson, executive director of NextFlex. “We continuously tackle member-identified FHE manufacturing challenges, and with 31 projects already underway from three previous project calls, we expect this to garner even more interest from the FHE community. Topics in Project Call 4.0 build upon successful developments and learning from our previous project calls.”
Project proposals should tackle industry-driven problems and offer solutions that include a plan for transitioning projects to the US industrial manufacturing base. The project proposals should focus on the following manufacturing thrust areas:
- FHE Device Encapsulation and Overmold;
- Advanced 3D Electrical Design Software Solution;
- Evaluation and Development of Connectors for FHE Devices and E-Textiles;
- Development of a Carrier System Appropriate for Sheet-to-Sheet FHE Manufacturing;
- High Layer Count FHE Processing with IC Interface Demonstration;
- Flexible Battery Integration Demonstration and Reference Designs
To demonstrate these manufacturing capabilities, project proposals can focus:
- Large-Area Sensor System for Structural Health Monitoring;
- Minimally Invasive Wearable Flexible Devices for Monitoring of Fluid-Based Biomarkers;
- Lightweight Flexible Electronics Platform on UAVs and Drones
More information on NextFlex’s PC 4.0, including proposal submission instructions, can be found here.